6mm Beads

[Kyle Wise]

Is anyone tying kokanee spinners with 6mm beads or staying smaller? Thanks for the responces.

 

[SuperD]

My spinners typically are 4mm, 5mm and a single 6mm as a center body bead.

 

[Bluknight]

I think I followed SuperD's method last year. This year I downsized by one just because they seemed kind of big. Not sure if that was a good idea because the old way work - hope I didn't screw that up.

Anyway my setup this year is 2-3-4-5-4-3-2

 

[Kyle Wise]

I'm going to make a few with 6mm beads to run on one side of the boat just to see if I can target bigger fish... who knows I'll probably end up with kings101bananna101

 

[SuperD]

Bluknight, looking at stacked beads on a wedding ring, they look like they are pretty close to your sizes. I don't think you'll have any problems catching fish with that combo.

 

[Fishin-RN]

I run all 6mm beads last year, but I'm going to invest in some 4's to mix it up a little.

 

[Mav186]

6mm are my primary size, then will use smaller beads with them depending on what profile I'm trying to create. They have always produced for me!