fishbiker
Well-known member
One of the things that are over looked are spark plugs, i had a guy bring me a seadoo that he had the carbs rebuilt some where and it still was not running good, after checking the
compression and it was good i ran the ski and with carb cleaner i spray into each carb one at a time and no change in the running, this will tell me if i have a fuel problem. this boat was running on one cylinder.
next was a spark check, even that there was spark on both plugs one was not a good color, he had cheap plugs like from walmart or something. i went to oreillys where they carry NGK and picked up some BR8ES plugs, gapped them and installed and problem solved. It is good to replace your plugs every season, use the manufacturers recomened plugs as some of the off brands just don,t last. Being new to wa. i am not sure but in ca. you must use a R (resistor) type plugs in marine as it is law there and most manufacturers use them due to the electronics in there engines. bad plugs can cause the boat to not run at all, run on all cylinders except one, can cause a misfire and bad low speed performance, its also good to replace the plug wires. Just some helpfull info from a retired mastertech
compression and it was good i ran the ski and with carb cleaner i spray into each carb one at a time and no change in the running, this will tell me if i have a fuel problem. this boat was running on one cylinder.
next was a spark check, even that there was spark on both plugs one was not a good color, he had cheap plugs like from walmart or something. i went to oreillys where they carry NGK and picked up some BR8ES plugs, gapped them and installed and problem solved. It is good to replace your plugs every season, use the manufacturers recomened plugs as some of the off brands just don,t last. Being new to wa. i am not sure but in ca. you must use a R (resistor) type plugs in marine as it is law there and most manufacturers use them due to the electronics in there engines. bad plugs can cause the boat to not run at all, run on all cylinders except one, can cause a misfire and bad low speed performance, its also good to replace the plug wires. Just some helpfull info from a retired mastertech
Last edited: